UV flatbed printer accessories troubleshooting
The faults of UV flatbed printer accessories are mainly broken water pipes, broken button switches, and fan failures. These failures can be directly observed through external performance, and the general treatment methods are directly replaced with new ones.
1, UV flatbed printer water pipe rupture
A. Abrasion for a long time, the solution: plastic water pipes will inevitably wear out for a long time. Replace the water pipes with new ones;
B. Freezing and cracking. If the temperature is too cold, the water pipe will be placed on the ground and frosting will occur. Solution: replace the new water pipe, install air-conditioning in the workshop, and provide heating;
C. Piercing injury, solution: In daily life, you can't pay attention to puncture by sharp objects, which can cause water pipe rupture. Replace the water pipe with a new one.
The water pipe is used for daily home improvement hardware stores, and the price is a few dollars a meter. If it is broken, it can be replaced by yourself.
2, UV flatbed printer button switch is damaged
A. The LED push button switch is damaged, the solution is to replace the new LED push button switch;
B. The suction button switch is damaged, the solution: replace the suction button switch with a new one;
C. The nozzle switch of the nozzle is damaged, the solution is to replace the button switch of the nozzle;
These small parts are available in daily hardware stores, and the price is only a few cents. If there is a problem, you can replace it yourself.
3.UV flatbed printer fan failure
A. The inner leaves sweep the church, the solution: if the individual does not dismantle the fan for maintenance, it is recommended that the manufacturer send a new replacement.
B. Burn-out, solution: contact and send a new replacement. The fan is covered by the warranty.