UV flatbed printer safety equipment requirements

      UV flatbed printer safety equipment mainly includes three aspects: power, ground, and mobile. Each part must be installed and banned accordingly. It must be strictly observed to prevent safety accidents.

UV flatbed printer safety equipment requirements

      UV flatbed printer safety equipment requirements

     1.UV flat printer is connected to 220V AC power, current 10A, maximum power 4500W;

     2. It is required that the voltage regulator is suitable for the voltage of the UV flatbed printer: basically refer to the minimum power of the equipment 3000-4500W to choose. It can play a regulating role when the unstable voltage is in order to prevent the unstable voltage from causing damage to electronic components in the circuit system;

    3.UV flatbed printer must be connected to the ground wire to provide a low-impedance connection between the device and the ground body to reduce the risk of personal injury from electric shock;

    4.Environmental requirements: Temperature requirements are 25-30 degrees, humidity requirements are 40% -70%, and there is no dust. When the temperature is lower than 25 degrees, the viscosity of the ink will increase, and the smoothness is not good. When printing, there will be other unknown phenomena such as broken ink and virtual needles. Excessive dust will greatly damage the nozzle. Excessive humidity will affect ink adhesion;

    5. The computer is equipped with a mechanical hard disk of more than 500G, running memory of more than 4G, 1G independent display, CPU I3 or I5; if necessary, an additional solid-state hard disk 120G can be added. Ensure that the software and hardware required to run the .uv flatbed printer can run without obstacles to meet the needs of storage and operation;

    6. Please remove all the external circuits of the UV flatbed printer, and make a mark and keep the bottom of the photo, remove the external device connection, and make a mark and keep the bottom of the photo. Raise the Foma wheel, lower the moving wheel, and push the moving wheel to the ground. During the process of moving the equipment, it is forbidden to push the beam to prevent the beam from being displaced and deformed. After reaching the scheduled location, contact the technician of the UV flatbed printer. With reference to the installation method of the technician, it will be handled by the following methods: maintenance, telephone, QQ, photos, on-site installation;

    7. If you need to bring the equipment into or out of the equipment: please contact a professional lifting company, and have a special equipment operation certificate and cooperation with qualifications to ensure life and equipment safety.


    UV flatbed printer safety equipment prohibition:

   1. It is forbidden to prevent articles in the moving part of the trolley and turn on the print mode: this will cause a strong impact and damage the nozzle;

   2. It is forbidden to touch the moving part of the cart in the print mode: because this will cause serious accidents and injuries;

   3. It is forbidden to prevent items in the moving part of the beam and enable printing mode: this will cause strong impact and damage the nozzle;

   4. It is forbidden to touch the moving part of the beam in the print mode: this will cause serious accidents and injuries;

   5. Children are not allowed to play near the device: during the operation or non-operation of the device, the device product has a high-speed movement or standby state. Once the switch is touched, it will cause serious accidents and injuries;

   6. It is forbidden to discard waste products containing ink mixtures in consumable lamps at random. They can be stored uniformly and delivered to the waste recycling processing station for unified processing. Be sure to turn off the secondary cache cartridge after shutdown: otherwise it will cause a series of problems Problems, serious failure to boot;

   7. It is forbidden to modify or replace other accessories: the modification or replacement of other accessories will cause the UV flatbed printer to fail to operate normally. If the input power supply is not clear, it will cause accidents, injuries, serious fires, and even fire;

   8. It is forbidden to select different types of consumables for mixing: replacing consumables of different brands or models will cause normal printing to be impossible, and severely cause the nozzle to be blocked;

   9. It is forbidden to use 380V three-phase power access, which will cause all equipment of the equipment to be burned.


cache
Processed in 0.006882 Second.